Archive for the ‘WAN’ Category

Free CCNA Lab IPV6 Frame-Relay

In this Free CCNA Lab you will configure three routers in a simple IPv6 hub and spoke Frame-Relay configuration. The Frame-Relay switch has already been configured. You will need to configure the routers using the predefined DLCIs. Routing will be established using static routing. Finally you will use the Show and Ping commands verify and […]

Free CCNA Lab Configuring Point-To-Point Encapsulation

In this lab activity, you will create a network that is similar to the one shown in the Topology Diagram. Begin by perform the initial router configurations required for connectivity. Use the IP addresses that are provided in the network diagram to apply an addressing scheme to the network devices. After completing the basic configuration, […]

Free CCNA Lab Configuring Point-To-Point Frame Relay

In this Free CCNA LAB Four routers must be interconnected in a hub-and-spoke Frame Relay configuration. Router R1 is the hub, and routers R2, R3, and R4 are spoke routers. The Frame Relay connections will be established using Frame Relay point-to-point connections over subinterfaces from R1 to each spoke router. Routing will be established using […]

Powered by WordPress | Designed by: backlinks | Thanks to internet marketing, etiketten drucken and index backlink